Lexmark T652 Service Manual - Page 113
Lexmark T652 Manual
View all Lexmark T652 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 113 highlights
4062 Error code or message 28x.51 x = bin number Error contents Description/Action Possible repair actions Right tamper home position jam Applies to: StapleSmart finisher The right tamper home position is not detected by the sensor (right tamper HP) 1. Check all the connections on the output option controller card. 2. Check the tamper drive belt for damage and replace if needed. 3. Replace the right tamper motor assembly. Go to "SFP stapler assembly tamper drive motor assembly removal" on page 4-180. 4. Replace the sensor (tamper HP). Go to "SFP stapler assembly sensor (tamper HP left and right) removal" on page 4-187. 4. Replace the output option if problem remains. 28x.52 x = bin number Paddle control motor timer error Applies to: StapleSmart finisher A software failure has occurred with the output option. 1. Turn the machine off/on. 2. Replace the output option if problem remains. 28x.53 x = bin number Eject motor encoder not detected Applies to: StapleSmart finisher The eject motor encoder is not detected upon startup 1. Check all the connections on the output option controller card. 2. Replace the output option if problem remains. 28x.54 x = bin number Eject motor encoder not detected Applies to: StapleSmart finisher The eject motor encoder detection is lost during normal operation. 1. Check all the connections on the output option controller card. 2. Replace the output option if problem remains. 28x.55 x = bin number Eject motor overspeed failure Applies to: StapleSmart finisher The eject motor rotate at the specified speed 1. Check all the connections on the output option controller card. 2. Replace the output option if problem remains. 28x.56 x = bin number Eject motor underspeed failure Applies to: StapleSmart finisher The eject motor rotate at the specified speed 1. Check all the connections on the output option controller card. 2. Replace the output option if problem remains. 28x.57 x = bin number Sensor (stapler pass through) static jam Applies to: StapleSmart finisher Media remains on the sensor (stapler pass through) during the warm up sequence. Go to sensor (stapler pass through) static jam service check. See "Sensor (stapler pass through) static jam service check" on page 2-149. Diagnostic information 2-79