Lexmark T652 Service Manual - Page 54

4062 Error code or message 201.26 Error contents Description/Action Possible repair actions Main drive motor assembly load error. Type 2 fuser The main drive motor assembly has failed or caused high mechanical load due to paper jam or bind. 1. Check all connections on the main drive motor assembly. 2. Check all connections on the system card assembly. 3. Replace the main drive motor assembly if problem remains. Go to "Output cover assembly removal (T650, T652, T654)" on page 4-54. Go to sensor (fuser output) late jam service check. See "Sensor (fuser output) late jam service check." on page 2-135. If problem remains, a type 2 fuser can be installed. 201.27 Sensor (fuser output) late jam. Type 2 fuser The media is late reaching the sensor (fuser output) within the specified time. 201.28 Image data did not start in time Type 2 fuser Printhead write failure 1. Check all connections on the printhead assembly 2. Check all connections on the system card assembly. 3. Replace the printhead assembly if problem remains. 4. Replace the system card assembly if problem remains. Go to "System card assembly removal (T650, T652, T654, T656)" on page 4-76. 201.29 Sensor (narrow media) late jam Type 2 fuser The expected wide media is late reaching the sensor (narrow media) within the specified time. Go to sensor (narrow media) late jam service check. See "Sensor (narrow media) late jam service check." on page 2-139. 1. Remove all media present in media path. 2. Ensure that the operator panel door assembly is fully open then fully closed. 3. Check operator panel door assembly for damage. 4. Check interlock switch (in left operator panel hinge) for damage. 5. Check all connections on the system card assembly. Go to sensor (narrow media) late jam service check. See "Sensor (narrow media) late jam service check." on page 2-139. 201.30 Operator panel door assembly interlock switch failure Type 2 fuser The printer detected that the operator panel door interlock switch did not cycle prior to printer restart. 201.31 Sensor (narrow media) late jam Type 2 fuser The expected wide media is late reaching the sensor (narrow media) within the specified time. 2-20 Service Manual