Lexmark T652 Service Manual - Page 40

4062 Error code or message 44.01 Error contents Description/Action Possible repair actions RFID Error Bad tag error: a tag has failed to program, or the "Retry Count" has been exceeded. Note: This error is not a data parsing error, but indicates bad RFID media. It is posted only if the "Stop on Error" menu setting is set to "ON". 1. Retest using new RFID media. 2. Check the RFID firmware card, RFID interface card, RFID cable, and RFID option for correct installation. Go to "High capacity input tray (HCIT) pick arm bracket assembly removal" on page 4-130. 3. Replace the RFID UHF option. 1. These error codes most likely indicate a problem with the customer's datastream, and not the RFID Option itself. Ensure there is nothing wrong with the customer's datastream. 2. Check the RFID firmware card, RFID interface card, RFID cable, and RFID option for correct installation. Go to "High capacity input tray (HCIT) pick arm bracket assembly removal" on page 4-130. 3. Replace the RFID UHF option. 44.11 44.12 44.13 44.14 44.15 44.16 44.17 44.18 44.19 44.20 44.21 44.22 44.23 44.24 44.25 RFID Error RFID Error RFID Error RFID Error RFID Error RFID Error RFID Error RFID Error RFID Error RFID Error RFID Error RFID Error RFID Error RFID Error RFID Error Generic parse error Subcommand appears truncated Subcommand appears longer than expected Subcommand field value was invalid Invalid subcommand format (invalid magic byte) Subcommand format valid but not supported Illegal chars in subcommand for specified format Invalid op code Valid but unsupported op code Invalid protocol Valid but unsupported protocol Unsupported option supplied for operation Invalid ID length Invalid ID bit pattern Too many tags on page (too many means more than one) 2-6 Service Manual