Lexmark T652 Service Manual - Page 65
Lexmark T652 Manual
View all Lexmark T652 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
4062 Error code or message 202.99 Error contents Description/Action Possible repair actions Fuser ID chip failure The system does not recognize the ID chip on the fuser unit. Replace the fuser unit assembly. Go to "Fuser unit assembly removal (T650, T652, T654)" on page 4-23, 203.00 Paper jam around redrive area. Page may be jammed in redrive area. 1. Remove all media present in media path. 2. Check media for proper installation. 3. Check for obstructions in media path. 4. Go to sensor (fuser output) service check. See "Sensor (fuser output) service check" on page 2-126. 5. Go to sensor (narrow media) service check. See "Sensor (narrow media) service check" on page 2-127. 1. Remove all media present in media path. 2. Check all connections on the duplex media entrance drive motor assembly. 3. Check all connections on the system card assembly. 4. Replace the duplex media entrance drive motor assembly if problem remains. Go to "Duplex drive motor assembly removal (T652, T654)" on page 4-19. 1. Remove all media present in media path. 2. Ensure that upper redive assembly is properly installed. 3. Check all connections on the redrive motor assembly. 4. Check all connections on the system card assembly. 5. Replace the redrive motor assembly if problem remains. Go to "Redrive assembly removal (T650, T652, T654)" on page 4-62. 203.01 Internal duplex drive motor control failure. Internal duplex The internal duplex drive motor motor does not reach the proper operating speed at the specified time. 203.08 Redrive motor load error The redrive motor assembly has failed or caused high mechanical load during the warm up sequence. Diagnostic information 2-31