Lexmark T652 Service Manual - Page 217

4062-XXX EP SETUP EP Defaults Fuser Temp Fuser Page Count Warm Up Time Transfer Print Contrast Charge Roll Gap Adjust EVENT LOG Display Log Print Log Clear Log EXIT DIAGNOSTICS See "Display Log" on page 3-23 See "Print Log" on page 3-23 See "Clear Log" on page 3-24 See "EP Defaults" on page 3-21 See "Fuser Temperature (Fuser Temp)" on page 3-21 See "Fuser Page Count" on page 3-21 See "Warm Up Time" on page 3-21 See "Transfer" on page 3-21 See "Print Contrast" on page 3-22 See "Charge Roll" on page 3-22 See "Gap Adjust" on page 3-22 Exiting Diagnostics mode (models T650, T652, and T654) Select Exit Diagnostics to exit the Diagnostics menu. Resetting the Printer displays, the printer performs a POR, and returns to Ready mode. REGISTRATION Print registration makes sure the printing is printed properly aligned on the page. The settings available are: Top Margin Bottom Margin Left Margin Right Margin Quick Test To set print registration: 1. Select REGISTRATION from the DIAGNOSTICS menu. 2. Select Quick Test, and press To print the Quick Test page: . a. Press b. Press until the appears next to Quick Test. . The message Quick Test Printing...appears on the display. Retain this page to determine the changes you need to make to the margins settings. 3. Use 4. Use or to select the margin setting you need to change, and press to increase the values, and press . to decrease or to reset the value. The message Submitting selection displays, and the original REGISTRATION screen appears with the beside the previously selected margin setting. Diagnostic aids 3-5