Lexmark T652 Service Manual - Page 224

4062-XXX 3. Load plain media in Tray 2, and then press Continue. The test page will be printed. If the page looks like this: If the page looks like this: T65x RFID Option Test Step 3. Step three is complete. If this image T65x RFID Option Test Step 3. Step three is complete. If this image appears at the bottom of this sheet, the test is a SUCCESS. appears at the bottom of this sheet, the test is a SUCCESS Then step 3 of the test passed and the RFID Option Test is complete. The RFID firmware and hardware are working properly. Then the test has failed. This is an indication that the printer was able to read an RFID tag when it was not supposed to. Possible causes: 1. RFID media was printed instead of plain media. 2. A separate RFID tag may be placed in close proximity to the RFID option. 3. RFID UHF option failure Try the test again, making sure that plain media is used for step 3. If the test fails again, inspect the printer to make sure there are no RFID tags in close proximity to the RFID option. For example, it an RFID tag was applied to the printer front cover itself, this tag may be causing problems with the RFID reader. If no problems found, replace the RFID UHF option. DUPLEX TESTS Quick Test (duplex) This test prints a duplex version of the Quick Test that can be used to verify that the correct placement of the top margin on the back side of a duplex page. You can run one duplexed page (Single), or continue printing 3-12 Service Manual