Lexmark T652 Service Manual - Page 67

4062 Error code or message 230.02 Error contents Description/Action Possible repair actions Sensor (duplex input) late jam Source = Internal duplex Media is late reaching the sensor (duplex input) within the specified time. Go to sensor (duplex input) late jam service check. See "Sensor (duplex input) late jam service check." on page 2-141. Go to sensor (duplex input) service check. See "Sensor (duplex input) service check" on page 2-127. Go to sensor (input) late jam service check. See "Sensor (input) late jam service check." on page 2-129. Go to sensor (duplex input) lingering jam service check. See "Sensor (pass through) late jam service check" on page 2-145. Go to sensor (input) late jam service check. See "Sensor (input) late jam service check." on page 2-129. Go to sensor (input) late jam service check. See "Sensor (input) late jam service check." on page 2-129. 1. Remove all media present in media path. 2. Check all connections on the duplex media entrance drive motor assembly. 3. Check all connections on the system card assembly. 4. Replace the duplex drive motor assembly if problem remains. Go to "Duplex drive motor assembly removal (T652, T654)" on page 4-19. 230.03 Sensor (duplex input) bounce Source = Internal duplex The sensor (duplex input) rebounded once the trailing edge of the media passed. 230.04 Sensor (input) late jam from duplex Source = Internal duplex Media is late reaching the sensor (input) within the specified time during the second side printing using the internal duplex. Media reached the sensor (duplex input) but did not clear it in the specified time. 230.05 sensor (duplex input) lingering jam Source = Internal duplex 230.06 Sensor (input) late jam from duplex Source = Internal duplex Media is late reaching the sensor (input) within the specified time during the second side printing using the internal duplex. Media is late reaching the sensor (input) within the specified time during the second side printing using the internal duplex. The internal duplex drive motor assembly has failed or caused high mechanical load during warm up sequence. 230.07 Sensor (input) late jam from duplex Source = Internal duplex 230.08 Internal duplex drive motor load error Source = Internal duplex Diagnostic information 2-33