Sharp MX-B402 MX-B402 MX-B402SC Operation Manual - Page 205

COPIER (1) Special Modes Erase Edge Erase Side Erase 3 (2) (3) OK Cancel OK Edge 1/2 (0~1) inch Select the erase settings. (1) Touch the desired erase mode. Select one of the 2 positions. Touch the [Side Erase] key to open the following screen. Erase Side Erase Up Cancel OK Erase Position for Original Side 2 Left Right Down Same Side as Side 1 Different Side from Side 1 Touch the checkbox of the edge that you wish to erase and make sure that a checkmark appears. When performing 1-sided to 2-sided copying or 2-sided to 2-sided copying, set the erase edge on the reverse side. • If you touch the [Same Side as Side 1] key, the edge in the same position as on the front side will be erased. • If you touch the [Different Side from Side 1], the edge in the position opposite to the erased edge on the front side will be erased. When you have completed the erase edge settings, touch the [OK] key. (2) Set the erasure width with . 0" to 1" (0 mm to 20 mm) can be entered. (3) Touch the [OK] key. You will return to the base screen of copy mode. Press the [START] key. Copying will begin. If you are using the document glass to copy multiple original pages, copying will take place as you scan each original. If you 4 have selected sort mode, change originals and press the [START] key. Repeat until all pages have been scanned and then touch the [Read-End] key. To cancel scanning of the original and copying... Press the [STOP] key ( ). If a ratio setting is used in combination with an erase setting, the erase width will change according to the selected ratio. For example, if the erase width setting is 1" (20 mm) and the image is reduced to 50%, the erase width will be 1/2" (10 mm). To cancel the erase setting... Touch the [Cancel] key in the screen of step 3. System Settings (Administrator): Erase Width Adjustment The default erase width can be set from 0" to 1" (0 mm to 20 mm). The factory default setting is 1/2" (10 mm). 2-47 Contents