Brother International Entrepreneur Pro PR-1000 Users Manual - English - Page 261

Memo ● Before installing the cap frame, be sure to adjust the ring of the cap frame driver and the height of the L-shaped bracket. (If the same machine is being used, this adjustment is only required the first time that it is used. In addition, this adjustment is not necessary if the included cap frame is installed.) ● After the ring of the cap frame driver and the height of the L-shaped bracket have been adjusted, they must be adjusted again if a different machine is being used. The height may differ depending on the machine that is used. For details, contact your Brother dealer. Note ● If the cap embroidery frame is attached, the embroidery frame indicators, showing which embroidery frames can be used, appear as shown below. Types of caps With the machine, we recommend that the following types of caps be embroidered. ■ Standard (Pro Style) 1 Face: Pro style 2 6 sections Otto International, Inc. cap model number (Example) Mesh backing on the back of front panels (soft or hard) Ease of framing (hooping) OTTO27-007 Constructed Unconstructed firm front soft crown Easy (Recommended) Fairly easy Backing 1 to 2 ply 2 to 3 ply ■ Low Profile (Low fitting) 1 Face: Low fitting 2 6 sections Otto International, Inc. cap model OTTO23-225 OTTO18-203 number (Example) Mesh backing 7 on the back of Constructed Unconstructed front panels firm front soft crown (soft or hard) Ease of framing (hooping) Very difficult (because the cap material is very hard.) Fairly easy Backing 1 to 2 ply 2 to 3 ply Using the Optional Cap Frame 259