Brother International Entrepreneur Pro PR-1000 Users Manual - English - Page 59

• Use spool cap on all spools of thread shorter than the height of the spool pin. Pass the thread through the hole (with the 3 corresponding needle bar number) in thread guide C, then through the corresponding hole in thread guide D. As an example, the threading for spool pin 1 is shown. 1 Spool mat 2 2 Small spool 3 Spool cap The numbers indicate the thread path for each of the numbered needle bars. Be very careful to correctly thread the needle bars. Pass the thread of a specified color through 2 the holes on the thread guide, making sure that you have the thread color matched to the coordinating needle bar. Pass the thread from spool pins 1, 3, 5, 6, 8 and 10 through the holes in both thread guides A and B. Pass the thread from spool pins 2, 4, 7 and 9 through the hole in thread guide B only. 1 Thread guide C 2 Thread tension lever 3 Holes in thread guide C 4 Thread guide D Note ● Before threading, make sure to slide the thread tension lever to the left so that the holes in thread guide C are fully open. ● After all upper threading is finished, be sure to slide the thread tension lever back to the right. Embroidering with the holes in thread guide C fully open may cause the thread to become tangled or break. 1 Thread guide A (There are 6 holes in this thread guide) 2 Thread guide B (There are 10 holes in this thread guide) 1 Thread tension lever 2 Holes in thread guide C Upper Threading 57