Brother International Entrepreneur Pro PR-1000 Users Manual - English - Page 301

The installed embroidery frame is The upper thread broke, the The bobbin thread broke or ran too small. thread came out of the thread out. Check which embroidery frames tension disc or a thread guide, or Check that there is thread on the can be used, and then install a the machine is not threaded bobbin and that approximately 50 larger embroidery frame. (Refer to correctly. mm (2 inches) of thread has been page 49.) Check that the thread passes under pulled out, and then re-install the the upper and middle thread bobbin. (Refer to page 38.) guides, and correctly thread the upper thread. (Refer to page 56.) If the thread is not broken, clean the thread guides and the tension unit. (Refer to page 285.) The patterns you are editing take up too much memory, or you are editing too many patterns for the memory. Sewing cannot begin from the The needle has stopped at an specified starting position. incorrect position. Change the starting position or Turn the handwheel so that the rehoop the fabric and change the mark on the handwheel is at the embroidering position. (Refer to 94, top. 135.) 7 The needle bar case could not be The needle bar case has stopped at The needle bar case motor has moved to its initial position. an incorrect position. locked up. Touch to automatically Touch to automatically Touch to automatically reset the needle bar case. reset the needle bar case. reset the needle bar case. Troubleshooting 299