Brother International Entrepreneur Pro PR-1000 Users Manual - English - Page 54

EMBROIDERING TUTORIAL Move the left arm to align the screw on the 2 right side with the mark for the embroidery frame to be installed, and then tighten the thumb screws. For this example, align with mark 5. Hold the embroidery frame level, and then 3 simultaneously align both the left and right mounts with the embroidery frame holder clips. 1 Mark for extra-large embroidery frame 200 mm (H) × 360 mm (W) (7-7/8 inches (H) × 14 inches (W)) 2 Mark for extra-large embroidery frame 200 mm (H) × 300 mm (W) (7-7/8 inches (H) × 11-3/4 inches (W)) (optional) 3 Mark for large embroidery frame 130 mm (H) × 180 mm (W) (5-1/8 inches (H) × 7-1/8 inches (W)) 4 Mark for medium embroidery frame 100 mm (H) × 100 mm (W) (4 inches (H) × 4 inches (W)) 5 Mark for small embroidery frame 40 mm (H) × 60 mm (W) (1-1/2 inches (H) × 23/8 inches (W)) Note ● Please firmly tighten the two thumb screws with included disc-shaped screwdriver. The machine will recognize the wrong frame size, if the two screws are not tightened. X The embroidery frame holder is ready for the embroidery frame to be attached. • The inner frame should be on top. Note ● Attach the embroidery frame to place the needle plate under the embroidering area otherwise the embroidery frame hits the needle plate. 1 Needle plate ● If the outer frame is on top, as shown below, the embroidery frame is incorrectly attached. Insert the embroidery frame until it snaps 4 into place. 1 Make sure that the pins on the left and right arms of the embroidery frame holder fit into the positioning slot and hole on the embroidery frame. 52