Brother International Entrepreneur Pro PR-1000 Users Manual - English - Page 267

Memo ● If there is a gap between the clamp of the thumb screw and the mounting surface, insert the included pad as shown below. ■ For the standard type Using a Phillips screwdriver, loosen the three screws (one each at the top and on the left and right sides) on the outside of the mounting jig two or three turns. 1 Mounting bracket 2 Mounting surface (worktable, desk, etc.) 3 Pad 4 Thumb screw Check that there is no looseness. 3 If there is looseness, mount the mounting jig onto the mounting surface again. Note ● Be sure that the mounting bracket is securely clamped onto the mounting surface and that the thumb screw is firmly tightened. ● Do not attach the mounting jig to an unstable surface (flexible, bent or warped). ● Be careful that the mounting jig does not fall when it is removed. Adjust the size of the mounting jig according 4 to the type (size) of cap being embroidered. 1 Screws 2 Phillips screwdriver Note ● Do not remove the three screws (one each at the top, left and right), otherwise they may be lost. Only turn the screws to slightly loosen them. 7 1 Low Profile (shorter caps) 2 Standard type (taller caps) Using the Optional Cap Frame 265