Brother International Entrepreneur Pro PR-1000 Users Manual - English - Page 264

APPENDIX Insert the two thumb screws at the bottom 4 of the cap frame driver into the v-cuts in the carriage, and then place the mounting plate of the cap frame driver on top of the framemounting plate of the carriage. Insert and tighten the two upper thumb 6 screws in outer holes of mounting plate of cap frame driver. While pushing in the cap frame driver 7 toward the machine so that it is fully inserted, tighten the two lower thumb screws to secure the cap frame driver. 1 Notch in the carriage 2 Thumb screw of the cap frame driver 3 Mounting plate of the cap frame driver 4 Frame-mounting plate of the carriage Insert the pins on the frame-mounting plate 5 of the carriage into the holes in the mounting plate of the cap frame driver. X This completes the installation of the cap frame driver. ■ Adjusting the cap frame driver 1 Pins on the frame-mounting plate of the carriage 2 Holes in the mounting plate of the cap frame driver 262 1 L-shaped bracket 2 Ring Memo ● If the same machine is being used, the adjustment to the cap frame driver is only required the first time that the machine is used.