Epson SureColor S70675 User Manual - Page 206

Item Heater Temperature Drying Time Per Pass After Heater Feed Additional Dryer Advanced Settings Parameter Pre-heater/platen heater: 30 °C to 50 °C (86 °F to 122 °F) After heater: 30 °C to 55 °C (86 °F to 131 °F) 0 to 10sec Mode 1 Mode 2 Off On Off Explanation The temperatures for the pre-, platen, and after heaters can each be adjusted separately. Select the time the print head pauses to allow drying after each pass. Choose from values between 0.0 and 10.0 seconds. The time needed for the ink to dry varies with ink density and the media used. If the ink blurs on the media, set a longer time for drying the ink. Increasing the drying time increases the time needed to print. To feed media to the after heater after printing, choose Mode 1 or Mode 2; otherwise, choose Off. If Mode 1 is selected, the portion fed for drying will not be rewound before the next job starts. Select this option if the media will be cut before the next job starts. If Mode 2 is selected, the portion fed for drying will be rewound before the next job starts, eliminating unnecessary margin. Select this option if multiple jobs will be printed consecutively. This item is displayed only when the additional print drying system is installed (supplied with the S50675 and optional with other models). Select On to enable, or Off to disable, the optional additional print drying system. Note that even when On is selected, the additional print drying system will turn off with the heaters when the Heat Off Timer expires. The additional print drying system will turn back on when the heaters resume operation. See "The Printer Setup Menu" on page 208. During general use, use the default setting value without changing it. When using special media or when a problem such as head striking or banding is detected in printing results, change the default. Using the Control Panel Menu 206