HP 6125XLG R2306-HP 6125XLG Blade Switch Fundamentals Configuration Guide - Page 99
System startup process, Upon power-on, the BootWare image runs to initialize hardware
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
This procedure assumes that the main image set and the backup image set have feature packages and patch packages. If an image set has neither feature packages nor patch packages, the system can use the image set to start up after the boot image and the system image passes verification. If neither the main boot image nor the backup boot image exists or is valid, connect to the console port and power cycle the device to access the BootWare menus for loading a boot image. For more information about downloading and loading a boot image, see the release notes for the software version. After accessing the emergency shell, connect to the console port and load a system image so you can access the Comware system. For more information about using the emergency shell, see "Using the emergency shell." Figure 25 Comware image loading procedure Start No Main boot image exists and valid? Yes Main system image No exists and valid? Yes All main feature No packages exist and valid? Yes Backup boot image No exists and valid? Yes No Backup system image exists and valid? Yes All backup feature No packages exist and valid? Yes Start up from BootWare menus Main boot image exists and valid? No Start up with backup boot image and access emergency shell Yes Start up with main boot image and access emergency shell No All patch packages exist and valid? Yes All backup patch No packages exist and valid? Yes Start up with main images Start up with backup images System startup process Upon power-on, the BootWare image runs to initialize hardware, and then the startup software images run to start up the entire system, as shown in Figure 26. To access the BootWare menus, you must press Ctrl+B within 1 second at the prompt. 92