HP LaserJet 5si HP LaserJet 5Si user guide - Page 155

Printer Messages, continued If the following errors persist, call your HP-authorized service provider. Message Description Recommended Action 31. X.Y DISK FAILURE The printer detected a disk failure. Printer operation may continue, if access to the disk is not required. Press [Select *] to continue printing when this error occurs. Call service to repair or replace the disk. 40.1 HP MIO ERROR 40.2 HP MIO ERROR An abnormal connection break occurred while transferring data from the computer. Error 40.1 is for port 1 (upper slot), and error 40.2 is for port 2 (lower slot). (If you are using an I/O other than the Bi-Tronics parallel I/O, refer to the user's manual for that product.) Press [Select *] to clear the error message. I/O connections on that MIO card will not be used. 41.1 GENERAL MISPRINT ERROR 41.2 BEAM DETECT MALFUNCTION 41.4 NO VIDEO SYNC 41.5 NOISY VIDEO SYNC REQ SIGNAL A nonfatal error has occurred in the printed page. Press [Select *] and attempt to continue. If problem persists, turn printer OFF and then back ON. 41.3 IMPROPER PAPER SIZE The printer detected that the actual paper size is not the same as the paper tray setting. Verify that the paper tray size is properly set. Trays 2, 3, and 4 are set by positioning the adjustment bars. Tray 1 is set via the tray menu on the printer control panel. 50.x FUSER ERROR CYCLE POWER The printer identified an internal service error (hardware problem with fuser). Switch the printer OFF and then back ON. 50.1 Fuser low-temperature failure 50.2 Fuser warm-up failure (timed out) 50.3 Fuser over-temperature failure 50.4 Fuser with wrong voltage 7-42 Maintenance and Troubleshooting Continued on the next page. EN