TP-Link TL-SG5426 User Guide - Page 191

3 Configuring the Switch Web - Click Priority, Queue Mode. Select Strict or WRR, then click Apply. Figure 3-87 Queue Mode CLI - The following sets the queue mode to WRR priority service mode. Console(config)#queue mode wrr Console(config)#exit Console#show queue mode Queue mode: wrr Console# 4-185 4-188 Setting the Service Weight for Traffic Classes This switch uses the Weighted Round Robin (WRR) algorithm to determine the frequency at which it services each priority queue. As described in "Mapping CoS Values to Egress Queues" on page 3-145, the traffic classes are mapped to one of the eight egress queues provided for each port. You can assign a weight to each of these queues (and thereby to the corresponding traffic priorities). This weight sets the frequency at which each queue will be polled for service, and subsequently affects the response time for software applications assigned a specific priority value. Command Attributes • Interface - Select port or trunk as an interface. • WRR Setting Table11 - Displays a list of weights for each traffic class (i.e., queue). • Weight Value - Set a new weight for the selected traffic class. (Range: 1-15) Web - Click Priority, Queue Scheduling. Select the required interface, highlight a traffic class (i.e., output queue), enter a weight, then click Apply. Figure 3-88 Configuring Queue Scheduling 11. CLI shows Queue ID. 3-148