TP-Link TL-SG5426 User Guide - Page 466
show ip redirects, Default Setting, Command Mode, Example, Related Commands, Syntax, count
UPC - 845973020729
View all TP-Link TL-SG5426 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 466 highlights
4 Command Line Interface show ip redirects This command shows the default gateway configured for this device. Default Setting None Command Mode Privileged Exec Example Console#show ip redirects IP default gateway 10.1.0.254 Console# Related Commands ip default-gateway (4-224) ping This command sends ICMP echo request packets to another node on the network. Syntax ping host [size size] [count count] • host - IP address or IP alias of the host. • size - Number of bytes in a packet. (Range: 32-512, default: 32) The actual packet size will be eight bytes larger than the size specified because the switch adds header information. • count - Number of packets to send. (Range: 1-16, default: 5) Default Setting This command has no default for the host. Command Mode Normal Exec, Privileged Exec Command Usage • Use the ping command to see if another site on the network can be reached. • Following are some results of the ping command: - Normal response - The normal response occurs in one to ten seconds, depending on network traffic. - Destination does not respond - If the host does not respond, a "timeout" appears in ten seconds. - Destination unreachable - The gateway for this destination indicates that the destination is unreachable. - Network or host unreachable - The gateway found no corresponding entry in the route table. • Press to stop pinging. 4-226