TP-Link TL-SG5426 User Guide - Page 479
cluster commander, cluster ip-pool, Syntax, Default Setting, Command Mode, Command Usage, Example
UPC - 845973020729
View all TP-Link TL-SG5426 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 479 highlights
4 Switch Cluster Commands cluster commander This command enables the switch as a cluster Commander. Use the no form to disable the switch as cluster Commander. Syntax [no] cluster commander Default Setting Disabled Command Mode Global Configuration Command Usage • Once a switch has been configured to be a cluster Commander, it automatically discovers other cluster-enabled switches in the network. These "Candidate" switches only become cluster Members when manually selected by the administrator through the management station. Example Console(config)#cluster commander Console(config)# cluster ip-pool This command sets the cluster IP address pool. Use the no form to reset to the default address. Syntax cluster ip-pool no cluster ip-pool ip-address - The base IP address for IP addresses assigned to cluster Members. The IP address must start 10.x.x.x. Default Setting 10.254.254.1 Command Mode Global Configuration Command Usage • An "internal" IP address pool is used to assign IP addresses to Member switches in the cluster. Internal cluster IP addresses are in the form 10.x.x.member-ID. Only the base IP address of the pool needs to be set since Member IDs can only be between 1 and 16. • Set a Cluster IP Pool that does not conflict with addresses in the network IP subnet. Cluster IP addresses are assigned to switches when they become Members and are used for communication between Member switches and the Commander. 4-239