TP-Link TL-SG5426 User Guide - Page 357

4 Command Line Interface Interface Commands These commands are used to display or set communication parameters for an Ethernet port, aggregated link, or VLAN. Table 4-42 Interface Commands Command Function Mode interface Configures an interface type and enters interface configuration GC mode description Adds a description to an interface configuration IC speed-duplex Configures the speed and duplex operation of a given interface IC when autonegotiation is disabled negotiation Enables autonegotiation of a given interface IC capabilities Advertises the capabilities of a given interface for use in IC autonegotiation flowcontrol Enables flow control on a given interface IC shutdown Disables an interface IC switchport broadcast Configures the broadcast storm control threshold IC packet-rate clear counters Clears statistics on an interface PE show interfaces status Displays status for the specified interface NE, PE show interfaces counters Displays statistics for the specified interfaces NE, PE show interfaces switchport Displays the administrative and operational status of an interface NE, PE Page 4-116 4-117 4-117 4-118 4-119 4-120 4-121 4-122 4-122 4-123 4-124 4-125 interface This command configures an interface type and enter interface configuration mode. Use the no form to remove a trunk. Syntax interface interface no interface port-channel channel-id interface • ethernet unit/port - unit - Stack unit. (Range: Unit 1) - port - Port number. (Range: 1-26) • port-channel channel-id (Range: 1-4) • vlan vlan-id (Range: 1-4094) Default Setting None 4-116