TP-Link TL-SG5426 User Guide - Page 439

4 Command Line Interface police This command defines an policer for classified traffic. Use the no form to remove a policer. Syntax [no] police rate-kbps burst-byte [exceed-action {drop | set}] • rate-kbps - Rate in kilobits per second. (Range: 1-100000 kbps or maximum port speed, whichever is lower) • burst-byte - Burst in bytes. (Range: 64-1522 bytes) • drop - Drop packet when specified rate or burst are exceeded. • set - Set DSCP service to the specified value. (Range: 0-63) Default Setting Drop out-of-profile packets. Command Mode Policy Map Class Configuration Command Usage • You can configure up to 64 policers (i.e., meters or class maps) for each of the following access list types: MAC ACL, IP ACL (including Standard ACL and Extended ACL). • Policing is based on a token bucket, where bucket depth (i.e., the maximum burst before the bucket overflows) is specified by the burst-byte field, and the average rate at which tokens are removed from the bucket is specified by the rate-bps option. Example This example creates a policy called "rd_policy," uses the class command to specify the previously defined "rd_class," uses the set command to classify the service that incoming packets will receive, and then uses the police command to limit the average bandwidth to 100,000 Kbps, the burst rate to 1522 bytes, and configure the response to drop any violating packets. Console(config)#policy-map rd_policy Console(config-pmap)#class rd_class Console(config-pmap-c)#set ip dscp 3 Console(config-pmap-c)#police 100000 1522 exceed-action drop Console(config-pmap-c)# 4-198