TP-Link TL-SG5426 User Guide - Page 438

4 Quality of Service Commands Example This example creates a policy called "rd_policy," uses the class command to specify the previously defined "rd_class," uses the set command to classify the service that incoming packets will receive, and then uses the police command to limit the average bandwidth to 100,000 Kbps, the burst rate to 1522 bytes, and configure the response to drop any violating packets. Console(config)#policy-map rd_policy Console(config-pmap)#class rd_class Console(config-pmap-c)#set ip dscp 3 Console(config-pmap-c)#police 100000 1522 exceed-action drop Console(config-pmap-c)# set This command services IP traffic by setting a CoS, DSCP, or IP Precedence value in a matching packet (as specified by the match command on page 4-194). Use the no form to remove the traffic classification. Syntax [no] set {cos new-cos | ip dscp new-dscp | ip precedence new-precedence |} • new-cos - New Class of Service (CoS) value. (Range: 0-7) • new-dscp - New Differentiated Service Code Point (DSCP) value. (Range: 0-63) • new-precedence - New IP Precedence value. (Range: 0-7) Default Setting None Command Mode Policy Map Class Configuration Example This example creates a policy called "rd_policy," uses the class command to specify the previously defined "rd_class," uses the set command to classify the service that incoming packets will receive, and then uses the police command to limit the average bandwidth to 100,000 Kbps, the burst rate to 1522 bytes, and configure the response to drop any violating packets. Console(config)#policy-map rd_policy Console(config-pmap)#class rd_class Console(config-pmap-c)#set ip dscp 3 Console(config-pmap-c)#police 100000 1522 exceed-action drop Console(config-pmap-c)# 4-197