TP-Link TL-SG5426 User Guide - Page 470
show ip source-guard, show ip source-guard binding
UPC - 845973020729
View all TP-Link TL-SG5426 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 470 highlights
4 Command Line Interface table, or static addresses configured in the source guard binding table with this command. • Static bindings are processed as follows: - If there is no entry with same VLAN ID and MAC address, a new entry is added to binding table using the type of static IP source guard binding. - If there is an entry with same VLAN ID and MAC address, and the type of entry is static IP source guard binding, then the new entry will replace the old one. - If there is an entry with same VLAN ID and MAC address, and the type of the entry is dynamic DHCP snooping binding, then the new entry will replace the old one and the entry type will be changed to static IP source guard binding. Example This example configures a static source-guard binding on port 5. Console(config)#ip source-guard binding 11-22-33-44-55-66 vlan 1 192.168.0.99 interface ethernet 1/5 Console(config-if)# Related Commands ip source-guard (4-227) ip dhcp snooping (4-231) ip dhcp snooping vlan (4-233) show ip source-guard This command shows whether source guard is enabled or disabled on each interface. Command Mode Privileged Exec Example Console#show ip source-guard Interface Filter-type Eth 1/1 DISABLED Eth 1/2 DISABLED Eth 1/3 DISABLED Eth 1/4 DISABLED Eth 1/5 SIP Eth 1/6 DISABLED show ip source-guard binding This command shows the source guard binding table. Command Mode Privileged Exec 4-230