TP-Link TL-SG5426 User Guide - Page 65

3 Configuring the Switch system interface becomes silent for a specified amount of time (set by the Silent Time parameter) before allowing the next logon attempt. (Range: 0-120; Default: 3 attempts) • Silent Time - Sets the amount of time the management console is inaccessible after the number of unsuccessful logon attempts has been exceeded. (Range: 0-65535; Default: 0) • Data Bits - Sets the number of data bits per character that are interpreted and generated by the console port. If parity is being generated, specify 7 data bits per character. If no parity is required, specify 8 data bits per character. (Default: 8 bits) • Parity - Defines the generation of a parity bit. Communication protocols provided by some terminals can require a specific parity bit setting. Specify Even, Odd, or None. (Default: None) • Speed - Sets the terminal line's baud rate for transmit (to terminal) and receive (from terminal). Set the speed to match the baud rate of the device connected to the serial port. (Range: 9600, 19200, 38400, 57600, 115200 baud, or Auto; Default: Auto) • Stop Bits - Sets the number of the stop bits transmitted per byte. (Range: 1-2; Default: 1 stop bit) • Password1 - Specifies a password for the line connection. When a connection is started on a line with password protection, the system prompts for the password. If you enter the correct password, the system shows a prompt. (Default: No password) • Login1 - Enables password checking at login. You can select authentication by a single global password as configured for the Password parameter, or by passwords set up for specific user-name accounts. (Default: Local) Web - Click System, Line, Console. Specify the console port connection parameters as required, then click Apply. 1. CLI only. 3-22 Figure 3-14 Console Port Settings