TP-Link TL-SG5426 User Guide - Page 411
switchport mode, Example, Related Commands, Syntax, trunk, hybrid, private-vlan, Default Setting
UPC - 845973020729
View all TP-Link TL-SG5426 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 411 highlights
4 Command Line Interface Example The following example shows how to set the interface configuration mode to VLAN 1, and then assign an IP address to the VLAN: Console(config)#interface vlan 1 Console(config-if)#ip address 192.168.1.254 255.255.255.0 Console(config-if)# Related Commands shutdown (4-121) switchport mode This command configures the VLAN membership mode for a port. Use the no form to restore the default. Syntax switchport mode {trunk | hybrid | private-vlan} no switchport mode • trunk - Specifies a port as an end-point for a VLAN trunk. A trunk is a direct link between two switches, so the port transmits tagged frames that identify the source VLAN. Note that frames belonging to the port's default VLAN (i.e., associated with the PVID) are also transmitted as tagged frames. • hybrid - Specifies a hybrid VLAN interface. The port may transmit tagged or untagged frames. • private-vlan - For an explanation of this command see "switchport mode private-vlan" on page 4-182. Default Setting All ports are in hybrid mode with the PVID set to VLAN 1. Command Mode Interface Configuration (Ethernet, Port Channel) Example The following shows how to set the configuration mode to port 1, and then set the switchport mode to hybrid: Console(config)#interface ethernet 1/1 Console(config-if)#switchport mode hybrid Console(config-if)# Related Commands switchport acceptable-frame-types (4-171) 4-170