TP-Link TL-SG5426 User Guide - Page 477
Switch Cluster Commands, show ip dhcp snooping
UPC - 845973020729
View all TP-Link TL-SG5426 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 477 highlights
4 Switch Cluster Commands show ip dhcp snooping This command shows the DHCP snooping configuration settings. Command Mode Privileged Exec Example Console#show ip dhcp snooping Global DHCP Snooping status: disable DHCP Snooping is configured on the following VLANs: 1 Verify Source Mac-Address: enable Interface ---------Eth 1/1 Eth 1/2 Eth 1/3 Eth 1/4 Eth 1/5 Trusted ---------No No No No Yes show ip dhcp snooping binding This command shows the DHCP snooping binding table entries. Command Mode Privileged Exec Example Console#show ip dhcp snooping binding MacAddress IpAddress Lease(sec) Type VLAN Interface 11-22-33-44-55-66 192.168.0.99 0 Static 1 Eth 1/5 Console# Switch Cluster Commands Switch Clustering is a method of grouping switches together to enable centralized management through a single unit. A switch cluster has a "Commander" unit that is used to manage all other "Member" switches in the cluster. The management station uses Telnet to communicate directly with the Commander throught its IP address, and the Commander manages Member switches using cluster "internal" IP addresses. There can be up to 16 Member switches in one cluster. Cluster switches are limited to within a single IP subnet. Command cluster cluster commander Table 4-79 Switch Cluster Commands Function Configures clustering on the switch Configures the switch as a cluster Commander Mode GC GC Page 4-238 4-239 4-237