TP-Link TL-SG5426 User Guide - Page 251

4 Command Line Interface The access mode shown in the following tables is indicated by these abbreviations: ACL (Access Control List Configuration) CM (Class Map Configuration) GC (Global Configuration) IC (Interface Configuration) LC (Line Configuration) MST (Multiple Spanning Tree) NE (Normal Exec) PE (Privileged Exec) PM (Policy Map Configuration) VC (VLAN Database Configuration) Line Commands You can access the onboard configuration program by attaching a VT100 compatible device to the server's serial port. These commands are used to set communication parameters for the serial port or Telnet (i.e., a virtual terminal). Table 4-5 Line Commands Command Function Mode Page line Identifies a specific line for configuration and starts the line GC 4-11 configuration mode login Enables password checking at login LC 4-11 password Specifies a password on a line LC 4-12 timeout login response Sets the interval that the system waits for a user to log into the LC 4-13 CLI exec-timeout Sets the interval that the command interpreter waits until user LC 4-13 input is detected password-thresh Sets the password intrusion threshold, which limits the number LC 4-14 of failed logon attempts silent-time* Sets the amount of time the management console is LC 4-15 inaccessible after the number of unsuccessful logon attempts exceeds the threshold set by the password-thresh command databits* Sets the number of data bits per character that are interpreted LC 4-15 and generated by hardware parity* Defines the generation of a parity bit LC 4-16 speed* Sets the terminal baud rate LC 4-17 stopbits* Sets the number of the stop bits transmitted per byte LC 4-17 disconnect Terminates a line connection PE 4-18 show line Displays a terminal line's parameters NE, PE 4-18 * These commands only apply to the serial port. 4-10