HP 6125G HP 6125G & 6125G/XG Blade Switches Network Management and Mon - Page 162
source interface
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 162 highlights
Description Use route-option bypass-route to enable the routing table bypass function to test the direct connectivity to the direct destination. Use undo route-option bypass-route to disable the routing table bypass function. By default, the routing table bypass function is disabled. When the routing table bypass function is enabled, the routing table is not searched, and the packet is sent directly to the destination in a directly connected network. Examples # Enable the routing table bypass function. system-view [Sysname] nqa entry admin test [Sysname-nqa-admin-test] type icmp-echo [Sysname-nqa-admin-test-icmp-echo] route-option bypass-route source interface Syntax source interface interface-type interface-number View undo source interface ICMP echo operation view Default level 2: System level Parameters interface-type interface-number: Specifies an interface by its type and number. Description Use source interface to configure the source interface for ICMP echo request packets. The ICMP echo request packets take the IP address of the source interface as their source IP address. The specified source interface must be up. Otherwise, no ICMP echo requests can be sent out. Use undo source interface to restore the default. By default, no source interface is configured for ICMP echo request packets. If you configure both the source interface command and the source ip command, the source ip command takes effect. Related commands: source ip. Examples # Specify the IP address of interface VLAN-interface 2 as the source IP address of ICMP echo request packets. system-view [Sysname] nqa entry admin test [Sysname-nqa-admin-test] type icmp-echo [Sysname-nqa-admin-test-icmp-echo] source interface vlan-interface 2 156