HP 6125G HP 6125G & 6125G/XG Blade Switches Network Management and Mon - Page 163
source ip, source port, DLSw, FTP, HTTP, ICMP echo, SNMP, TCP, UDP echo, UDP jitter
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 163 highlights
source ip Syntax source ip ip-address View undo source ip DLSw, FTP, HTTP, ICMP echo, SNMP, TCP, UDP echo, UDP jitter, voice operation view Default level 2: System level Parameters ip-address: Specifies the source IP address of a test operation. Description Use source ip to configure the source IP address of probe packets. The specified source IP address must be the IP address of a local interface. The local interface must be up. Otherwise, no probe packets can be sent out. Use undo source ip to remove the configured source address. The IP address of the interface that sends a probe packet serves as the source IP address of the probe packet. By default, no source IP address is configured for probe packets. If you configure both the source interface command and the source ip command, the source ip command takes effect. Related commands: source interface. Examples # Configure the source IP address of the ICMP echo packets as 10.1.1.1. system-view [Sysname] nqa entry admin test [Sysname-nqa-admin-test] type icmp-echo [Sysname-nqa-admin-test-icmp-echo] source ip 10.1.1.1 source port Syntax source port port-number View undo source port SNMP, UDP echo, UDP jitter, voice operation view Default level 2: System level Parameters port-number: Specifies the source port number of probe packets, in the range of 1 to 50000. 157