HP 6125G HP 6125G & 6125G/XG Blade Switches Network Management and Mon - Page 47
info-center loghost source
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Enter a correct log host IP address. The system prompts an invalid address if an incorrect IP address, such as an IPv6 loopback address, or the broadcast address, is entered. The switch supports up to four log hosts. Examples # Output log information to the log host 1.1.1.1. system-view [Sysname] info-center loghost 1.1.1.1 # Output log information to the log host 1.1.1.2 in vpn1. system-view [Sysname] info-center loghost vpn-instance vpn1 1.1.1.2 # Output log information to the log host 1::1. system-view [Sysname] info-center loghost ipv6 1::1 info-center loghost source Syntax info-center loghost source interface-type interface-number View undo info-center loghost source System view Default level 2: System level Parameters interface-type interface-number: Specifies the egress interface for log information by the interface type and interface number. Description Use info-center loghost source to specify the source IP address for output log information. Use undo info-center loghost source to restore the default. By default, the source IP address of output log information is the primary IP address of the matching route's egress interface. The system uses the primary IP address of the specified egress interface as the source IP address of log information no matter which physical interface is used to output the log information. If you want to display the source IP address in the log information, you can configure it by using this command. The info-center loghost source command takes effect only after the information center is enabled with the info-center enable command. The IP address of the specified egress interface must have been configured. Otherwise, although the info-center loghost source command can be configured successfully, the log host cannot receive any log information. 41