HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual (53-1000240-0 - Page 228

2 Note: Enter commands in lowercase only; mixed case is for readability. fcrEnable fcrEnable Enables the FC Routing service on the switch. Synopsis fcrenable Description Use this command to enable the Fibre Channel (FC) Routing service on a switch. In Fabric OS v5.1 the FC Routing service is enabled by default. In Fabric OS v5.2 the FC Routing service is disabled by default, and this commmand must be executed to enable it. Use fosConfig --show to determine the default state of the FC Routing service, and then use the appropriate operands to enable or disable it. This command can be run while the switch state is "online". If fcrEnable is issued while the switch is still busy disabling the FC routing feature (for instance, right after a fcrDisable was issued), the message "FC Routing service is in the process of being disabled, please try again after a few minutes." will be displayed. If this happens, just wait a few minutes before again issuing fcrEnable. Use switchShow or fosConfig to display the current state of the FC Routing service. If issued while the FC Routing service is already enabled, then the message, "FC Routing service is already enabled" is displayed. Operands none Examples To enable the FC Routing service: fcr:admin> fcrenable FC Routing service is enabled See Also fcrConfigure, fcrDisable, fosConfig, switchDisable, switchEnable, switchShow 2-194 Fabric OS Command Reference Manual Publication Number: 53-1000240-01