HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual (53-1000240-0 - Page 663

Note: Enter commands in lowercase only; mixed case is for readability. snmpMibCapSet 2 snmpMibCapSet Modifies options for configuring SNMP MIB trap capability. Synopsis snmpmibcapset Description This command enables a user to turn on or off certain MIBs and traps. This command also enables a user to turn on or off group information and SSN in SW trap messages. It first displays current settings and then prompts the user to change the values for each parameter. FA-MIB Specifying yes means the user can access FA-MIB variables with an SNMP manager. The default value is yes. HA-MIB Specifying yes means the user can access Entity-MIB and HA-MIB variables with an SNMP manager. The default value is yes. SW-TRAP Specifying yes means the SNMP management application can receive SWTRAPS from the switch. The default value is yes. FA-TRAP Specifying yes means the SNMP management application can receive FA-TRAPS from the switch. The default value is yes. SW-EXTTRAP Specifying yes means the SNMP management application can receive SWEXTTRAPS from the switch. The default value is yes. HA-TRAP Specifying yes means the SNMP management application can receive HATRAPS from the switch. The default value is yes. Note Traps in pre-Fabric OS v4.4.x code were turned on and off as a group (such as SW-TRAP and FATRAP); it was not possible to set individual traps (such as swSensorStatusChangeTrap, swTrackChangesTrap, or connUnitEventTrap). You can now individually turn traps on and off, which means that individual traps need to be turned on explicitly after the corresponding trap group is turned on. Because pre-v4.4.x software has only trap group settings, after upgrading to v4.4.x or later, individual traps are turned off by default even if the corresponding trap group is turned on before upgrading. If you have been previously monitoring these traps, use either snmpMibCapSet or snmpConfig to turn on the desired traps individually. See the Fabric OS MIB Reference Manual for more information. Note The execution of this command is subject to Admin Domain restrictions that may be in place. Operands none Fabric OS Command Reference Manual Publication Number: 53-1000240-01 2-629