HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual (53-1000240-0 - Page 528

2 Note: Enter commands in lowercase only; mixed case is for readability. portLogShow disable State (refer to state codes next) enable Mode: 0 normal; non-zero loopback Tx & RxHeader words 0,1,4 (R_CTL,D_ID,S_ID,OX_ID,RX_ID) and the first payload word reject FC-PH reject reason busy FC-PH busy reason ctin Argument 0 is divided into two 16-bit fields: [A] a bit map indicating whether subsequent args are valid (0001 means argument 1 is valid, 0003 means arguments 1 and 2 are valid). [B] the CT-based service command code. Argument 1 is the first word of the CT payload, if applicable (as specified in [A]). Argument 2 is the second word of the CT payload, if applicable (as specified in [A]). ctout Argument 0 is also divided into two 16-bit fields: [A] a bit map indicating whether subsequent args are valid (0001 means argument 1 is valid, 0003 means arguments 1 and 2 are valid). [B] the CT command code indicating whether an accept (8002) or a reject (8001). If [B] is an accept, argument 1 and 2 represents the first and second words of the CT payload, if applicable (as specified in [A]). If [B] is a reject, argument 1 contains the CT reject reason and explanation code. errlog Error type (refer to errShow) loopscn The meaning further depends on each loop state: OLP Offline reason code, usually zero LIP Reason code for LIPs initiated by FL_Port, if the code value is 800x (x = [1,0xc], see below), or the lower two bytes of the LIP received, if the code value is other than 800x LIM Usually zero BMP Memory address for the loop bitmap OLD Usually zero TMO Encoded value of the state when loop init timed out This value is usually equal to the first word of a loop init frame payload. Other possible values include: 2 LIP (req. INITIALIZING) timeout 94F0F0 ARB(F0) timeout 40 CLS timeout Codes used in various fields are as follows: state 2-494 Fabric OS Command Reference Manual Publication Number: 53-1000240-01