HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual (53-1000240-0 - Page 476

2 Note: Enter commands in lowercase only; mixed case is for readability. portCfgDefault portCfgDefault Restores the port configuration to factory default values. Synopsis portcfgdefault [slotnumber/][ge]portnumber Description Use this command to reset any special configuration values on a port to their factory defaults. This command will disable ports capable of routing persistently, which is the factory default value. You can view the current port configuration using the portCfgShow command. This command does not change the state of a port. To make an E_Port go back to the online state, use either switchDisable/switchEnable or portDisable/portEnable. Note The execution of this command is subject to Admin Domain restrictions that may be in place. Operands Examples This command has the following operands: slotnumber For bladed systems only, specify the slot number of the port to display, followed by a slash (/). portnumber Specify the number of the port to be returned to default values, relative to its slot for bladed systems. Use switchShow to list valid ports. To reset a port to factory defaults: switch:admin> portcfgdefault 1/3 To reset a GbE port to factory defaults: switch:admin> portcfgdefault 8/ge1 See Also portCfgEPort, portCfgGPort, portCfgLongDistance, portCfgLPort, portCfgPersistentDisable, portCfgPersistentEnable, portCfgShow, portCfgSpeed, portCfgTrunkPort 2-442 Fabric OS Command Reference Manual Publication Number: 53-1000240-01