HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual (53-1000240-0 - Page 659

Note: Enter commands in lowercase only; mixed case is for readability. snmpConfig 2 HA-TRAP Specifying yes means the SNMP management application can receive HA traps from the switch. The default value is 'yes'. Users can also turn on or off individual HA Traps. The individual HA Traps are fruStatusChanged, cpStatusChanged, and fruHistoryTrap. Operands systemGroup Configuration Parameters sysDescr sysLocation sysContact authTraps The system description. The default value is set as Fibre Channel Switch. The location of the system (switch). The default value is set as End User Premise. The contact information for this system (switch). The default value is set as Field Support. Refer to the definition of sysDescr, sysLocation and sysContact in system group of MIB-II. When enabled, the authentication trap (authenticationFailure) is transmitted to a configured trap recipient in the event that the agent received a protocol message that is not properly authenticated. In the context of SNMPv1 and SNMPv2c, this means that a request contains a community string that is not known to the agent. The default value for this parameter is 0 (disabled). This command supports following operands: --show Displays the SNMP agent configuration data of the specified category. --set Sets the SNMP agent configuration data of the specified category. This operand displays the current settings and then prompts you to change the values for each parameter. --default Sets the SNMP agent configuration data for a specified item to the default values. Generally, these default values might be available in the configuration database. It sets to factory default settings if the SNMP agent configuration parameters are not available in the configuration database. --show, --set, and --default supports the following: snmpv1 Selects SNMPv1-related configuration parameters. SNMPv1 parameters include the community string, trap recipient IP address, and trap severity level associated with each trap recipient IP address. snmpv3 Selects SNMPv3-related configuration parameters. SNMPv3 parameters include user name, authentication protocol and password, SNMPv3 trap recipients IP address, associated user index, and trap severity level. accessControl Selects access-control-related parameters. accessControl parameters include access host subnet area and access permission (read-write). mibCapability Selects configuration parameters related to the SNMP agent's MIBs and trap capability parameters. mibCapability parameters include MIBs and traps supported by the SNMP agent. systemGroup Selects configuration parameters related to the system group. systemGroup parameters include sysDescr, sysLocation, sysContact, and authentication failure trap. Fabric OS Command Reference Manual Publication Number: 53-1000240-01 2-625