HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual (53-1000240-0 - Page 667

Note: Enter commands in lowercase only; mixed case is for readability. spinFab 2 spinFab Runs functional test of switch-to-switch ISL cabling and trunk group operation. Synopsis spinfab [-nmegs count][-ports itemlist][-setfail mode] Description Use this command to verify the intended functional operation of the ISL links between switches. At the maximum speed of 4 Gbit/sec, set the routing hardware such that test frames received by each E_Port retransmit on the same E_Port. Next, send several frames to the neighbor port attached to each active E_Port specified. The default action for such frames is to route them back to the sender, which never occurs for normal traffic. The frames circulate until the test stops them. The frames are continuously transmitted and received in all ports in parallel. The port LEDs flicker green rapidly while the test is running. While the frames are circulating, the RX frame count and port CRC and encoder error statistics are monitored and errors will be generated if a port stops or a low-level error occurs. Every one million frames, the circulating frames are captured to verify that they are still circulating and that they are still in-order. In this manner, the entire path to the remote switch might be verified, as can be the proper in-order delivery operation of any trunk groups present. The switch remains in normal operation while this test is running; however, some performance degradation occurs due to the ISL links being saturated with test frames. Because of this, you should use caution when running this test on live fabrics. Consider only testing one trunk group or ISL link at a time, and do not run the tests for extended periods of time. This test is best combined with the online crossPortTest for ISL link-failure isolation. If this test fails, replace the cable with a loop-back plug and run crossPortTest to verify the local switch and media. If these pass, the fault lies in the cable or remote switch and media. The frames are continuously transmitted and received in all ports in parallel. The port LEDs flicker green rapidly while the test is running. Note When trunk groups are present, the entire trunk group must be included in the range of ports to test or false failures can occur. If multiple ISL links are present between two switches that support trunking, then it is likely that trunk groups are present and all ports between the two switches should be tested at the same time. Note The execution of this command is subject to Admin Domain restrictions that may be in place. Operands This command has the following operands: -nmegs count Specify in millions the number of frames to send. The test will progress until the specified number of frames has been transmitted on each port. The default value is 10 million frames. This command only approximately counts the frames and the actual number of frames sent will be slightly larger, particularly at 2 Gbit/sec link speeds. -ports itemlist Specify a list of user ports to test. By default, all of the ISL ports in the current switch will be tested. Refer to itemList help pages for further details. -setfail mode Instruct spinFab how to mark failed ports. If set to 1, it will mark failing ports as FAILED. If set to 0, it will not mark failed ports as FAILED. It is to minimize the impact on live fabrics. This test normally logs errors but does not set the port status Fabric OS Command Reference Manual Publication Number: 53-1000240-01 2-633