HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual (53-1000240-0 - Page 478

2 Note: Enter commands in lowercase only; mixed case is for readability. portCfgEXPort portCfgEXPort Sets a port to be an EX_Port, and sets and displays EX_Port configuration parameters. Synopsis portcfgexport [slotnumber/]portnumber [-a admin][-f fabricid][-r ratov][-e edtov][-d domainid] [-p pidformat][-t fabric_parameter][-m port mode] Description Use this command to configure a port as an EX_Port. This command also displays and changes a port's EX_Port configuration. If no optional operands are given, this command displays the currently configured values; otherwise, it sets the specified attributes to the new values. The port must be disabled (for example, using portDisable) prior to setting EX_Port attributes. The port must be enabled (using portEnable) before the port can become active following EX_Port parameter changes. When the port is not active, the preferred domain ID is configurable. This is the domain ID that is used by the EX_Port's front phantom domain to request a domain ID from the principal switch. The domain ID received becomes the subsequent preferred domain ID which is persistent and displayed. The fabric ID must be the same for every router port connected to the same edge fabric, and different for every edge fabric. If two ports are connected to the same fabric but have been assigned different fabric IDs, one of them is disabled due to a fabric ID oversubscription. If two fabrics have been assigned the same fabric ID, one of them is disabled due to a fabric ID conflict. When a port is changed from FL_Port to EX_Port, the topology is implicitly changed to point-to-point. Front domain WWN field displays the WWN of the front domain. If the port is enabled and the state is "OK", the edge fabric principal switch's domain ID and WWN also are displayed. If the Fabric Parameter value is "Auto Negotiate", the port ID format, R_A_TOV, and E_D_TOV values display the negotiated values indicated by "(N)" next to them. The negotiated values are what the edge switch specifies in the ELP request. If the state is "Not OK", the R_A_TOV and E_D_TOV display "Not Applicable". By default, all EX_Ports are auto-ELP enabled. If the Fabric Parameter attribute value is "User configured", the port ID format R_A_TOV and E_D_TOV values display the configured values. Note The execution of this command is subject to Admin Domain restrictions that may be in place. Operands This command has the following operands: -a admin Specify whether to enable or disable this port as an EX_Port. Valid values are 1 (enable as EX_Port), 2 (disable as EX_Port, in other words, enable as nonEX_Port). portCfgDefault can also be used to disable EX_Ports. -f fabricid Specify the fabric ID. Valid values are 1-128. -r ratov Specify the R_A_TOV used for port negotiation. Valid values are 2000 - 120000. This operand is only applicable if the "Fabric Parameter" attribute value is not "Auto Negotiate". -e edtov Specify the E_D_TOV used for port negotiation. Valid values are 1000 - 60000. This operand is only applicable if the "Fabric Parameter" attribute value is not "Auto Negotiate". -d domainid Specify the preferred domain ID. Valid values are 1-239. 2-444 Fabric OS Command Reference Manual Publication Number: 53-1000240-01