HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual (53-1000240-0 - Page 317

Note: Enter commands in lowercase only; mixed case is for readability. ifModeSet 2 Examples To advertise all modes of operation, when not entering this command through the serial console port, follow this scenario for the ifModeSet command: switch:admin> ifmodeset eth0 Exercise care when using this command. Forcing the link to an operating mode not supported by the network equipment to which it is attached may result in an inability to communicate with the system through its ethernet interface. It is recommended that you only use this command from the serial console port. Are you sure you really want to do this? (yes, y, no, n): [no] y Proceed with caution. Auto-negotiate (yes, y, no, n): [no] y Advertise 100 Mbps / Full Duplex (yes, y, no, n): [yes] y Advertise 100 Mbps / Half Duplex (yes, y, no, n): [yes] y Advertise 10 Mbps / Full Duplex (yes, y, no, n): [yes] y Advertise 10 Mbps / Half Duplex (yes, y, no, n): [yes] y Committing configuration...done. To force the link for the eth0 interface from auto-negotiation to 10 Mbit/sec half-duplex operation, when entering this command through the serial console port: switch:admin> ifmodeset eth0 Auto-negotiate (yes, y, no, n): [yes] n Force 100 Mbps / Full Duplex (yes, y, no, n): [no] n Force 100 Mbps / Half Duplex (yes, y, no, n): [no] n Force 10 Mbps / Full Duplex (yes, y, no, n): [no] n Force 10 Mbps / Half Duplex (yes, y, no, n): [no] y Committing configuration...done. See Also ifModeShow Fabric OS Command Reference Manual Publication Number: 53-1000240-01 2-283