HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual (53-1000240-0 - Page 231

Note: Enter commands in lowercase only; mixed case is for readability. fcrPathTest 2 7. RANDOM 0x25, 0x7f, 0x6e, 0x9a, ... Note This command is supported only on SilkWorm FR4-18i blades and SilkWorm 7500 platforms. Operands Examples This command has the following operands: --slot slotnumber Specifies the slot number on which the diagnostic operates. The default is 0 and operates on fixed-port-count products. -unit number Specifies the FC Router FPGA to test. By default, all FC Router FPGA in the specified slotnumber are used. Valid number values include: 0 FC Router FPGA 0 1 FC Router FPGA 1 2 All FC Router FPGA -path mode Specifies the loopback point for the test. By default, fcrPathTest uses central ASIC loopback. Valid mode values include: 1 Central ASIC loopback 2 FC Router FPGA Serdes loopback 3 FC Router FPGA internal loopback -nmegs count Specifies the number of frames to send. The test progresses until the specified number of frames are transmitted on each port. The default value is 10. To test slot 2 with FC Router FPGA Serdes loopback sending 10 frames: switch:admin> fcrpathtest --slot 2 -path 2 -nmegs 10 Running fcrpathtest Test Complete: fcrpathtest Pass 10 of 10 Duration 0 hr, 0 min & 18 sec (0:0:18:942). passed. Diagnostics See Also When a failure is detected, the test might report one or more of the following: • DATA • ERRSTAT • INIT • PORTDIED • STATS • TIMEOUT • XMIT fcrChipTest, miniCycle, portLoopbackTest Fabric OS Command Reference Manual Publication Number: 53-1000240-01 2-197