HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual (53-1000240-0 - Page 756

2 Note: Enter commands in lowercase only; mixed case is for readability. uRouteShow uRouteShow Displays unicast routing information. Synopsis urouteshow [slotnumber/][portnumber][domain] Description Use this command to display the unicast routing information for a port, as it is known by the FSPF path selection and routing task. The routing information describes how a frame that is received from a port on the local switch is to be routed to reach a destination switch. The following information displays: Local Domain ID Domain number of local switch. In Port Port from which a frame is received. Except for the cases in which you perform a port swap or enable extended-edge PID (PID Format 2) on a switch, the value is equal to the Area field displayed by the switchShow command. Refer to Fabric OS Administrator's Guide for more information regarding the extended-edge PID format. Domain Destination domain of incoming frame. Out Port Port to which the incoming frame is to be forwarded. Except for the cases in which you perform a port swap or enable extended-edge PID (PID Format 2) on a switch, the value is equal to the Area field displayed by the switchShow command. For port swap operations, the value is equal to the Swport field displayed by the portSwapShow command. Refer to Fabric OS Administrator's Guide for more information regarding the extended-edge PID format. Metric Cost of reaching the destination domain. Hops Maximum number of hops required to reach the destination domain.If the number of hops are different for some multiple equal cost paths (to reach the same domain), then it will display the maximum number. Flags Indicates if route is dynamic (D) or static (S). A dynamic route is discovered automatically by the FSPF path selection protocol. A static route is assigned using the command uRouteConfig. Next (Dom, Port) Domain and port number of the next hop. These are the domain number and the port number of the switch to which Out Port is connected. The information provided by this command should match what is provided by portRouteShow and topologyShow. Note The execution of this command is subject to Admin Domain restrictions that may be in place. Operands This command has the following operands: slotnumber For bladed systems only, specify the slot number of the input port whose routes are displayed, followed by a slash (/). portnumber Specify the number of the input port whose routes are to be displayed, relative to its slot for bladed systems. Use switchShow to display a list of valid ports. This operand is optional; if omitted, the command displays routing information for all input ports in the switch. 2-722 Fabric OS Command Reference Manual Publication Number: 53-1000240-01