HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual (53-1000240-0 - Page 547

Note: Enter commands in lowercase only; mixed case is for readability. portShow 2 No_Light Module is not receiving light. No_Sync Receiving light but out of sync. In_Sync Receiving light and in sync. Laser_Flt Module is signaling a laser fault. Port_Flt Port marked faulty. Diag_Flt Port failed diagnostics. Lock_Ref Locking to the reference signal. portScn Last State Change Notification for port. port generation number Port generation number for the last offline state change. portId 24-bit port ID. portIfId User port's interface ID. portWwn Port WWN. portWwn of devices(s) connected WWNs of connected devices. Distance The port's long-distance level. In case of LD mode, the user configured desired distance and actual distance also are displayed. Refer to portCfgLongDistance. portSpeed The port's fixed speed (1, 2, or 4 Gbit/sec) or negotiated speed (N1, N2, N4 Gbit/ sec or AN). EX_Port Mode The port is configured as an EX_Port. None of the EX_Port information is displayed if the port is not configured as an EX_Port. Fabric ID The fabric ID assigned to this EX_Port; therefore, it is the fabric ID of the edge fabric attached to this EX_Port. Front Phantom Information on the front phantom domain presented by this EX_Port. This information includes the preferred (if not active) or actual (if active) domain ID for the front domain and the WWN of the front domain. Pr Switch Info Information on the principal switch of the edge fabric attached to this EX_Port. This information includes the domain ID and WWN of the principal switch. BB XLate Information on the xlate (translate) phantom domain presented at this port. This information includes the preferred (if not active) or actual (if active) domain ID for the xlate phantom domain and the WWN of the xlate phantom domain . The xlate phantom domain connected at this port is in the same fabric as the router and represents the edge fabric connected to the EX_Port. Authentication Type If the EX_Port is connected to an edge switch with no security, then the authentication is displayed as "None". If the edge switch is in secure mode, and Fabric OS Command Reference Manual Publication Number: 53-1000240-01 2-513