HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual (53-1000240-0 - Page 234

2 Note: Enter commands in lowercase only; mixed case is for readability. fcrProxyConfig fcrProxyConfig Displays or configures proxy devices presented by an FC Router. Synopsis fcrproxyconfig [-s importedFID devWWN slot][-r importedFID devWWN] Description Use this command to display or set the persistent configuration of proxy devices presented by the local FC Router. If no optional operand is provided, the command displays the persistent proxy device configuration; otherwise, it sets the specified attributes to its new value. The proxy device must be inactive prior to setting or clearing persistent attributes. Disabling EX_Ports (using the portDisable command) attached to the relevant edge fabric, removing the device from the appropriate LSAN zones, or disabling the physical device are valid methods of ensuring a proxy device is inactive. Persistent proxy device configuration attributes apply to the local FC Router. Multiple FC Routers attached to the same edge fabric coordinate to present the same proxy devices. As a result, persistent proxy device configurations must be consistent across all FC Routers attached to the same edge fabric or unpredictable results will occur. If the proxy device configuration is not altered, no action is required. If the configuration is altered, then care must be taken to ensure consistency across all FC Routers attached to the same edge fabric. The following information is displayed if no optional operand is given: importedFID The imported fabric ID of the proxy device. devWWN The port World Wide Name of the device. Slot The slot used for the device WWN. The device WWN-to-slot association is persistently stored. The slot format is XXYYH, where XX specifies the translate domain area_ID (valid values include F0H through FFH) and YY specifies the port_ID value or the low 8-bits of the proxy device address (valid values include 01H through 7FH). The address of the proxy device is derived from the PID format (for example, native, core, or extended edge) and the proxy device slot. "All slots empty" is displayed if no proxy device WWN is stored in any slot for all edge fabrics. Note The execution of this command is subject to Admin Domain restrictions that may be in place. Operands This command has the following operands: -s importedFID devWWN slot Adds the specified devWWN (format: xx:xx:xx:xx:xx:xx:xx:xx) to the specified slot (format XXYYH, where XX is the translate domain area_ID [F0H through FFH] and YY is the port_ID [01H through 7FH]) for the edge fabric specified (1 through 128). "WWN does not exist in any proxy device slot" is displayed if the WWN does not exist in any slot for the specified edge fabric. "Too many proxy slots configured. Remove some unused proxy device WWNs from their slots using the -r operand and try again." is displayed if all slots are used for the specified edge fabric. 2-200 Fabric OS Command Reference Manual Publication Number: 53-1000240-01