HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual (53-1000240-0 - Page 250

2 Note: Enter commands in lowercase only; mixed case is for readability. ficoncupset ficoncupset Sets FICON-CUP parameters for a switch. Synopsis ficoncupset fmsmode enable | disable ficoncupset modereg bitname 0 | 1 Description Use this command to set FICON-CUP (Control Unit Port) parameters for a switch. All the parameters described below can be set while the switch is online. Changes to parameters are effective immediately. A reboot is not required for the changes to take effect. Note The execution of this command is subject to Admin Domain restrictions that may be in place. Operands Examples This command has the following operands: fmsmode Enable or disable the FICON Management Server (FMS) mode for the switch. When the operand is fmsmode, the argument is either enable or disable. Note If you use PID Format 2, you cannot enable fmsmode. modereg Set a bit in the FICON-CUP mode register. When the operand is modereg, one of the following bitname operands should be specified, followed by 0 or 1: POSC Programmed offline state control UAM User alert mode ASM Active=saved mode DCAM Director clock alert mode ACP Alternate control prohibited HCP Host control prohibited To enable FMS mode for the switch: switch:admin> ficoncupset fmsmode enable fmsmode for the switch is now Enabled To set ASM bit in the mode register for the switch: switch:admin> ficoncupset modereg ASM 1 Active=Saved Mode bit is set to 1 See Also ficoncupshow 2-216 Fabric OS Command Reference Manual Publication Number: 53-1000240-01