HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual (53-1000240-0 - Page 260

2 Note: Enter commands in lowercase only; mixed case is for readability. filterTest Operands Examples This command has the following operands: --slot slotnumber Specify the slot number on which the diagnostic operates. The port specified are relative to this slot number. The default is 0 and designed to operate on fixed-portcount products. -passcnt passcnt Specify the number of times to perform this test. The default value is 1. -txports itemlist Specify the user port numbers to perform this test. All user ports are set by default. -scamoff offset Specify the program location to write SCAM test data in SCAM memory. The default value is 0. The maximum offset number is set if the specified number is larger than the limit. -dcamoff offset Specify the program location to write DCAM test data in DCAM memory. The default value is 0. The maximum offset number is set if the specified number is larger than the limit. -fdefoff offset Specify the program location to write filter test definition data in filter definition memory. The default value is 0. The maximum offset number is set if the specified number is larger than the limit. To run a frame filter test: switch:admin> filtertest -txports 3/1-3/3 Running filtertest Test Complete: filtertest Pass 1 of 1 Duration 0 hr, 0 min & 2 sec (0:0:2:679). passed. Diagnostics When it detects failures, the subtest might report one or more of the following error messages: DIAG-ACTTEST DIAG-FLTINIT DIAG-FLTRCV DIAG-FLTXMIT DIAG-NUMTEST Refer to the Fabric OS Message Reference for more information. See Also itemList 2-226 Fabric OS Command Reference Manual Publication Number: 53-1000240-01