HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual (53-1000240-0 - Page 488

2 Note: Enter commands in lowercase only; mixed case is for readability. portCfgNPIVPort portCfgNPIVPort Enables or disables N_Port ID virtualization (NPIV) functionality on a port. Synopsis portcfgnpivport [slotnumber/]portnumber, mode Description Use this command to enable or disable NPIV functionality on a port. NPIV is applicable to an F_Port only. By default, NPIV is enabled for all Condor ASIC-based ports and disabled for all Bloom ASICbased ports. The following conditions must be met for a switch port to respond to NPIV requests from an NPIV device: NPIV capable NPIV capability is a switch blade or port attribute that is required for NPIV functionality to operate. Some blades within a switch, or some ports within a switch or blade, might not have NPIV capability. NPIV functionality cannot be enabled on such ports and they will not respond to NPIV requests. NPIV enabled NPIV functionality must be enabled on a port for it to respond to NPIV requests. By default, NPIV is enabled on all Condor ASIC-based ports and disabled on all Bloom ASIC-based ports. It can be selectively enabled or disabled on switch ports using this command. NPIV HA For a redundant control processor (CP) system to enable NPIV functionality, it must be running NPIV-enabled firmware versions on both the active and standby CPs. This requirement does not apply to single CP systems. Up to a maximum of 255 virtual port IDs are allocated per NPIV port. The maximum number of virtual IDs can be configured from 0 to 255 per port. The default value is 126 per port. The number of virtual port IDs per switch also can be configured. See configure for more information on configuring these values. Changes made by this command are persistent across switch reboots and power cycles. Use the portCfgShow command to display whether NPIV is enabled on a port. Use the portCfgDefault command to reset all port configurations, including the NPIV configuration of a port. Note The execution of this command is subject to Admin Domain restrictions that may be in place. Operands This command has the following operands: slotnumber For bladed systems only, specify the slot number of the port to be configured, followed by a slash (/). portnumber Specify a port number to be configured, relative to its slot for bladed systems. Use switchShow to display a list of valid ports. mode Specify 1 to enable and 0 to disable the NPIV function. 2-454 Fabric OS Command Reference Manual Publication Number: 53-1000240-01