HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual (53-1000240-0 - Page 656

2 Note: Enter commands in lowercase only; mixed case is for readability. snmpConfig snmpConfig Manages the SNMP agent configuration. Synopsis snmpConfig --show | --set | --default [snmpv1 | snmpv3 | accessControl | mibCapability | systemGroup] Description Use this command to manage the configuration of the SNMP agent in the switch. The configuration includes SNMPv1 and SNMPv3 configuration, access control list (ACL), MIB capability, and system group. It supports set, reset to default, and display operations. Issue this command with incomplete parameters and it displays the command usage. All values successfully changes by this command take effect immediately and are persistent across power cycles and reboots. For dual-domain systems, this command is specific to the SNMP agent associated with the current switch. Note The execution of this command is subject to Admin Domain restrictions that may be in place. SNMPv1 Configuration Parameters There are six communities, respective trap recipients and trap recipient severity level supported by the agent. The first three communities are for read-write (rw) access and the last three are for read-only (ro) access. The default value for the trap recipient of each community is 0.0.0.0. The length of community string should be in range of 2 to 16 characters. The default values for the community strings are: • Community 1: Secret C0de • Community 2: OrigEquipMfr • Community 3: private • Community 4: public • Community 5: common • Community 6: FibreChannel Note When secure mode is enabled, community strings can be changed on the primary FCS switch only and propagates changes across the fabric. For an SNMP management station to receive a trap generated by the agent, the administrator must configure a trap recipient to correspond to the IP address of the management station. In addition, the trap recipient must be able to pass the access control list (ACL) check as described in accessControl category. Trap Recipient Severity Level The event trap level in conjunction with the an event's severity level. When an event occurs and if its severity level is at or below the set value, the SNMP traps, Event Trap traps (swEventTrap, connUnitEventTrap and swFabricWatchTrap), are sent to configured trap recipients. By default, this value is set at 0, implying that no Event Trap is sent. Possible values are • 0 None • 1 Critical 2-622 Fabric OS Command Reference Manual Publication Number: 53-1000240-01