Yamaha 02R96 Owner's Manual - Page 150

Editing Plug-Ins 137 MIN/MAX: These parameters determine the minimum and maximum values of the MIDI data transmitted when each parameter control is adjusted. Use the PARAMETER ID/NAME parameter to select a Parameter ID from 1-4, and then edit as necessary. VAL: This is used to select the format for converting parameter control values to the DATA parameter's VAL setting. It applies to the currently selected bank. The available options are listed in the following table. VAL Description One byte Transmit the lower 7 bits of the parameter value as 1 word MSB/LSB LSB/MSB 2 Nibbles M 3 Nibbles M 4 Nibbles M 2 Nibbles L 3 Nibbles L 4 Nibbles L Transmit the lower 14 bits of the parameter value in 7-bit units starting from the upper byte Transmit the lower 14 bits of the parameter value in 7-bit units starting from the lower byte Transmit the lower 8 bits of the parameter value in 4-bit units, consecutively from the highest data Transmit the lower 12 bits of the parameter value in 4-bit units, consecutively from the highest data Transmit the parameter value in 4 bit units, consecutively from the highest data Transmit the lower 8 bits of the parameter value in 4-bit units, consecutively from the lowest data Transmit the lower 12 bits of the parameter value in 4-bit units, consecutively from the lowest data Transmit the parameter value in 4-bit units, consecutively from the lowest data VAL count Up to one VAL Up to two VAL's Up to two VAL's Up to two VAL's Up to three VAL's Up to four VAL's Up to two VAL's Up to three VAL's Up to four VAL's When the controls at the bottom of the Plug-In Edit page are operated, the specified MIDI data, along with the value of the parameter control, is transmitted. Plug-In parameters can also be adjusted by using Parameter controls 1-4, which correspond to the four parameters shown at the bottom of the Plug-In Edit page. Parameter controls 1-4 When a Y56K card effect, or an internal effects processor is inserted in the currently selected channel, when the EFFECTS/PLUG-INS [CHANNEL INSERTS] button is pressed, the corresponding EFFECTS/PLUG-INS [1-4] button indicator flashes, and the corresponding Effects, or Plug-In edit page appears. If it's a Y56K card that's inserted, the [PLUG-INS] button indicator also flashes. If it's an internal effects processor, the [INTERNAL EFFECTS] button indicator also flashes. This applies only to effects that are inserted into channels. If there's nothing inserted in the currently selected channel, a message appears. The parameter settings, and the target and bank for each Plug-In are stored in Scenes. When a Scene is recalled, if the Plug-In's Target is the same as when the Scene was stored, the parameters are set accordingly and the corresponding MIDI data is transmitted (so long as the REMOTE parameter is set to ENABLED). If the Target is not the same, the parameters are set accordingly but no MIDI data is transmitted. 02R96-Owner's Manual