Yamaha 02R96 Owner's Manual - Page 177
MIDI Port Setup, Use the DISPLAY ACCESS [SETUP] button to locate the MIDI/TO HOST Setup - pro tools
View all Yamaha 02R96 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 177 highlights
164 Chapter 17-MIDI MIDI Port Setup MIDI ports are configured as follows. 1 Use the DISPLAY ACCESS [SETUP] button to locate the MIDI/TO HOST Setup page. 2 Use the cursor buttons to select the parameters, and use the Parameter wheel, INC/DEC buttons, and [ENTER] button to set them. TO HOST SERIAL: These buttons are used to configure the TO HOST SERIAL port for use with either a Mac or PC. Caution: When a PC is connected to the TO HOST SERIAL port, do not set this to Mac because your PC may crash. GENERAL: These parameters are used to select ports for general MIDI data transmission and reception, including Program Changes for recalling Scenes, Control Changes for real-time parameter control, and Note On/Off for use with the Freeze effect. Available ports include: MIDI, SERIAL 1-8, USB 1-8, and SLOT1 1-8. MIDI THRU: These parameters allow you to route the incoming MIDI data from one port through to another port. Available ports include: MIDI, SERIAL 1-8, USB 1-8, and SLOT1 1-8. REMOTE1: This parameter is used to select a port for the Remote Layer. Available ports include: MIDI, SERIAL 1-8, USB 1-8, and SLOT1 1-8. If Pro Tools is selected as the target for a Remote Layer, "Pro Tools" is displayed here and no settings can be made. Studio Manager: These parameters are used to select a port for use with the Studio Manager software and to assign the 02R96 an ID from 1 to 8. Available ports include: MIDI, SERIAL 1-8, USB 1-8, and SLOT1 1-8. See the Studio Manager documentation for more information. DAW: These parameters are used to select ports for use with DAWs. Since three ports are required to control DAWs, ports are selected in groups of three, as follows: 1-3, 2-4, 3-5, 4-6, 5-7, 6-8. Available ports include: SERIAL, USB, and SLOT1. PLUG-IN1-4: These parameters are used to select ports for use with the Plug-Ins. If a Waves Plug-In card is installed in a Slot, the number of that Slot is displayed and no settings can be made. If the Plug-In target is set to USER DEFINED, you can select a port from MIDI, SERIAL 1-8, USB 1-8, or SLOT1 1-8. Ports for User Defined Plug-Ins can also be set on the Plug-In Setup page (see page 135). Note: Some functions cannot share ports. If you try to assign a port that's already assigned to such a function, the message "Change Port?" appears. If you select YES, the port will be assigned to the selected function and the previously assigned function will be set to "NO ASSIGN." 02R96-Owner's Manual