Yamaha 02R96 Owner's Manual - Page 37

24 Chapter 2-Control Surface & Rear Panel AD Input Section AD Input #1 is shown at the top; AD Inputs #17 and #18 below A INPUT A & B (BAL) connectors AD Inputs 1 through 16 feature balanced XLR-3-31-type connectors and balanced 1/4-inch 1 phone jacks, both with a nominal input range of -60 dB to +10 dB. Phantom powering (+48 V) is supplied to the XLR-type connectors, with individual ON/OFF switches on each input. The phone jacks, which can also be used with unbalanced phone plugs, have priority over the XLR-type connectors, so when a phone plug is inserted, the XLR-type connector 2 is disconnected. AD Inputs 17-24 feature balanced 1/4-inch phone jacks. AD Inputs can be patched individually to the Input Channels or Insert Ins. See "AD Input Section" on page 39 for more information. Male XLR plug 1 (ground) 3 (cold) 1/4" TRS phone plug Tip (hot) Ring (cold) 2 (hot) Sleeve (ground) 1 B INSERT I/O +4dB (UNBAL) connectors (AD 1-16) These unbalanced 1/4-inch TRS phone jacks are used to insert external signal processors, etc., into AD Inputs 1 through 16. They are wired: sleeve-ground, ring-return, tip-send. The nominal signal level is +4 dB. Inserts can be turned on and off individually by using the INSERT ON/OFF switches. See "AD Input Section" on page 39 for more information. 1/4" phone plug Tip (send) Tip (send) Ring (return) 1/4" TRS phone plug To processor's input Sleeve (ground) Sleeve (ground) Connect to INSERT jack 1/4" phone plug Tip (return) From processor's output Sleeve (ground) Analog Master I/O Section 12 3 45 6 A STUDIO MONITOR OUT +4 dB (BAL) These balanced 1/4-inch TRS phone jacks, nominal output level +4 dB, output the analog Studio Monitor signal for 1/4" TRS phone plug Tip (hot) Ring (cold) monitoring in the actual studio. The source, which is selected by using the STUDIO buttons in the MONITOR Sleeve (ground) section, can be Aux Send #7, Aux Send #8, the Stereo Out, or Control Room. The output 02R96-Owner's Manual